Tried search but didn't find answers to these general questions so wanted to give a post a try...
1) On the FR24 website, I want to edit my elevation and lat/long info because I moved my antenna. On the FR24 flight stats page I edit my coordinates and I can change the elevation, but the lat/long fields are grayed out. Is there another place that I can/should be using to change lat/long settings?
2) In terminal when executing fr24feed-status, one of the rows says "Receiver: connected (644247 MSGS/0 SYNC). Is that SYNC number supposed to be 0? What does that message mean?
3) I'm running fine on wifi, but when I plug an ethernet cable into my Pi then my FR24 feed breaks. I'm assuming this is because the wired connection has a different IP address according to ifconfig(???). If I want to run on the cable, where do I need to change that IP address to try to get my feed re-started?
Thanks, John
1) On the FR24 website, I want to edit my elevation and lat/long info because I moved my antenna. On the FR24 flight stats page I edit my coordinates and I can change the elevation, but the lat/long fields are grayed out. Is there another place that I can/should be using to change lat/long settings?
2) In terminal when executing fr24feed-status, one of the rows says "Receiver: connected (644247 MSGS/0 SYNC). Is that SYNC number supposed to be 0? What does that message mean?
3) I'm running fine on wifi, but when I plug an ethernet cable into my Pi then my FR24 feed breaks. I'm assuming this is because the wired connection has a different IP address according to ifconfig(???). If I want to run on the cable, where do I need to change that IP address to try to get my feed re-started?
Thanks, John
Comment