Feeder not working

[marful]

Hi All,

Very new to this so please bear with me.

I've downloaded RTL1090 and that's running and detected aircraft. I've run fr24feed and configured as best as I can understand

RTL1090 shows a TCP connection and fr24feed shows "avr-tcp, Connected".

But Aircraft tracked/Aircraft uploaded stays stubbornly at 0 and in My Account on Flightradar, it shows my client as offline. Any ideas on where to start?

Below is a screenshot. Any help appreciated.

drift.jpg

[marful]

He's a screeny from the feed page.

decoder.PNG

[marful]

OK, I think I've got it working by just using the feeder, rather than RTL1090.. I will report back

[Amper]

Why do you use rtl1090. Just use fr24 feed and Receiver: "DVB-T sick"

[marful]

Yeah... just figured that out :P

I was following a guide on a different website that said I needed RTL1090.. which obviously I don't

Is it possible to see a map of what I am detected? Other than on this website?

[marful]

I seem to get a lot of aircraft without full details.. I take it there are aircraft without the fully compliant ModeS ?

Capture.PNG

[Amper]

Or your antenna/antenna position is not ok