Originally posted by Oblivian
View Post
Originally posted by Oblivian
View Post
In Flightawar's Piaware img, the --net switch is set on by default. The gmap starts showing out of the box.
I opened the page http://<IP address of RPi>:8754/settings.html, and in the BLANK Field "Process arguments" entered "--net --net-http-port 8080", and page http://<IP Address of RPi>:8080/ started showing map with aircrafts
PI24 Settings.png . Pi24 Map.png
In the above map there are very few planes, as it is lowest traffic time (1 am in night), and the antenna is located in a room where signal are weak.
The Pi24 instructions page does not have any guide how to do the setting, or how to enter FR24Key if you already have one.
When I burned Pi24 image and inserted the microSD card in existing Pi, and reached "activate", the response was the station with MAC address of my RPi is already registered, send email to get a new key.
I tried to open settings page http://<IP Address of RPi>:8754/settings.html, it wont open.
I had to run command "fr24feed --fr24key=xxxxxxxxxxxxxx (xxxxxxxxxx is my existing key), then only the settings page opened, but it was blank. The key was not saved, neither there was any other entry.
I entered the following settings
Sharing Key: xxxxxxxxxxxxxxxxx
Receiver: DVB-T Stick
Host: localhost:30002
Process arguments: --net --net-http-port 8080
Then Pressed SAVE button on bottom right of settings page, then pressed RESTART button, also on bottom right.
The commandline method to configure is:
Code:
sudo fr24feed --reconfigure --fr24key=YOUR SHARING KEY #Complete the configuration wizard. #When asked for additioal arguments for dump1090, enter following: --net --net-http-port 8080 #After completing configuration, restart the feed sudo service fr24feed restart
Code:
sudo fr24feed --signup
The RPi B+ & Cantenna used in above experiment:
Pi B Plus and Cantenna .jpg
The food can is 2-11/16 inches dia x 3 inches height (7 US fl. oz).
In metric units, it is about 68mm dia x 76mm height (205 mL). If measured with rims, it is about 70mm dia x 80 mm height.
The Whip is 1/4 wavelength (67mm) long, made of core wire of RG6 coax with white core insulation. Shield & braid were removed.
Comment