Page 10 of 10 FirstFirst ... 8910
Results 91 to 93 of 93

Thread: Start of my RPi journey

  1. #91
    Join Date
    Apr 2018
    The rtl-sdr LNA has filters integrated, no need for extra filtering.

    Power is supplied via the coax. (bias-t)

    They even link a bias-t on their product page:

    Alternatively you can buy a dongle that has an internal bias-t to supply 5 V to the coax.
    (rtl-sdr v3 dongle, activated via software. nooelec nesdr smartee, always on)

    If you go the way of an external bias-t i'd recommend putting a 10 Ohm resistor in series, makes the LNA run a lot cooler.
    It should be fine running hot, but i was experimenting and it performance is fine at 3.3 V
    Last edited by wiedehopf; Today at 05:57.

  2. #92
    Join Date
    Apr 2013
    Brisbane, Australia
    Thanks wiedehopf, as I already have a dongle, it seems easier to get the rtl-sdr LNA then link the bias-t to the coax near my RPi, where I can keep an eye on it. As I am not into radio kits etc, finding and soldering a 10 Ohm resistor in series is way above my skill grade. Thanks for your help, much appreciated.

  3. #93
    Join Date
    Apr 2018
    Well you connect the external bias-t to wires anyway.
    (granted you can buy some that take a USB cable input)

    One of the wires you instead connect to the resistor and other end of the resistor to the bias-t.
    It's not exactly rocket science.

    Anyway you can use the 5V off the RPi to power the bias-t.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts