Hi all
I am trying to migrate to Pi24, I have read a lot of posts here but most of it is too technical.
I have the account set up but not seeing any aircraft being tracked.
I am wondering if I need to use Dump1090 with my receiver. One forum post here says that sometimes the MicroADSB USB receiver is a DVB-T one.
My receiver is this one from microadsb.com
The status page for my pi24 install is this
The settings page is
The command line in Pi24 has
When I was using this receiver in Plane Plotter it was set to an AVR receiver. In Pi24 I ahve tried the MicroADSB option first then AVR, I could be doing something wrong but neither of those seemed to work.
Any help would be appreciated
Mark
I am trying to migrate to Pi24, I have read a lot of posts here but most of it is too technical.
I have the account set up but not seeing any aircraft being tracked.
I am wondering if I need to use Dump1090 with my receiver. One forum post here says that sometimes the MicroADSB USB receiver is a DVB-T one.
My receiver is this one from microadsb.com
The status page for my pi24 install is this
The settings page is
The command line in Pi24 has
When I was using this receiver in Plane Plotter it was set to an AVR receiver. In Pi24 I ahve tried the MicroADSB option first then AVR, I could be doing something wrong but neither of those seemed to work.
Any help would be appreciated
Mark
Comment