UP front... apologies.. I'm clueless here! Only exposure before this was the standard flightaware image which I never tweaked.
I've built a fresh install onto SD card using the fr24 image. It's up and running to a point, but 1090dump is NOT running.
When I visit http//myip:8754 this is what I'm seeing:
Settings behind that are:
When I visit my dump1090 page. the map shows the following error message:
I've installed it afresh a couple of times... but am at a loss as to where I've messed up! I've got SSH ok...
HELP!!
I've built a fresh install onto SD card using the fr24 image. It's up and running to a point, but 1090dump is NOT running.
When I visit http//myip:8754 this is what I'm seeing:
FR24 Link: Connected via UDP
FR24 Radar Code: T-EGPH192
Local IP(s): 192.168.1.154
Aircraft Tracked:
(ModeS & ADS-B) 0
Aircraft Uploaded: N/A
Receiver: beast-tcp, Connected
MLAT running: NO
FR24 Radar Code: T-EGPH192
Local IP(s): 192.168.1.154
Aircraft Tracked:
(ModeS & ADS-B) 0
Aircraft Uploaded: N/A
Receiver: beast-tcp, Connected
MLAT running: NO
Receiver: ModeS Beast TCP
Host/ip: 127.0.0.1:30005
Baudrate: default
Host/ip: 127.0.0.1:30005
Baudrate: default
Problem fetching data from dump1090.
AJAX call failed (error: Not Found). Maybe dump1090 is no longer running?
The displayed map data will be out of date.
AJAX call failed (error: Not Found). Maybe dump1090 is no longer running?
The displayed map data will be out of date.
HELP!!
Comment