Hi!
I only have a few days to fix my receiver that has been offline for 3 months now and since Fr24 support takes too long to answer I figured I would seek help here on the forums instead. I got the receiver from fr24, so it's not one I built myself.
It failed in an update 3 monts ago, somehow. it just got stuck and stopped sending data to Fr24, even though I could reach its webinterface.
I flashed a new image to the SD card, but it never showed up on the network and the lights never started to blink, so I figured that maybe the SD card was corrupt.
I bought a new one and flashed the image again, but still no blinking lights.
So now I hooked it up to a monitor to see if I can get some error messages, and yep.
It seems that the DHCP service cannot start, It cannot get an IP so it reboots. It gets stuck in a reboot loop.
The error messages are:
And then further down:
And then:
Then it reboots, and the same thing goes over and over again.
The image is not the Raspberry pi image on their website, its "fr24-skysense-v1.1.0.img"
What can I do?
I only have a few days to fix my receiver that has been offline for 3 months now and since Fr24 support takes too long to answer I figured I would seek help here on the forums instead. I got the receiver from fr24, so it's not one I built myself.
It failed in an update 3 monts ago, somehow. it just got stuck and stopped sending data to Fr24, even though I could reach its webinterface.
I flashed a new image to the SD card, but it never showed up on the network and the lights never started to blink, so I figured that maybe the SD card was corrupt.
I bought a new one and flashed the image again, but still no blinking lights.
So now I hooked it up to a monitor to see if I can get some error messages, and yep.
It seems that the DHCP service cannot start, It cannot get an IP so it reboots. It gets stuck in a reboot loop.
The error messages are:
Code:
[FAILED] Failed to start Create Volatile Files and Directories. See ‘systemctl status systemd-tmpfiles-setup.service’ for details.
Code:
[FAILED] Failed to start dhcpd on all interfaces. See ‘systemctl status dhcpd.service’ for details.
Code:
[FAILED] Failed to start Raise network interfaces. See ‘systemctl status networking.service’ for details.
The image is not the Raspberry pi image on their website, its "fr24-skysense-v1.1.0.img"
What can I do?
Comment