Hello All -
I have a RaspberryPi 3b with the Pi24 image installed. I'm very new to doing this but very enthusiastic.
While my receiver is working and submitting data I've discovered that unfortunately, in my enthusiasm, I set up my Pi24 before locating the Quick Start Guide. Having read that now I realize I've answered a couple questions incorrectly such as the receiver type selection, if I'd like to enable RAW data feed, and if I'd like to enable Basestation data feed. Also, I also made the mistake of running the script that suggested after the activation page malfunctioned. The quick start guide says that I should not have done this.
So... to fix this, should I format the SD card and start fresh or can I fix this by rerunning the fr24feed --signup command?
Thank you!
I have a RaspberryPi 3b with the Pi24 image installed. I'm very new to doing this but very enthusiastic.
While my receiver is working and submitting data I've discovered that unfortunately, in my enthusiasm, I set up my Pi24 before locating the Quick Start Guide. Having read that now I realize I've answered a couple questions incorrectly such as the receiver type selection, if I'd like to enable RAW data feed, and if I'd like to enable Basestation data feed. Also, I also made the mistake of running the script that suggested after the activation page malfunctioned. The quick start guide says that I should not have done this.
So... to fix this, should I format the SD card and start fresh or can I fix this by rerunning the fr24feed --signup command?
Thank you!
Comment