Apologies in advance if this is a common problem.
So I'm using win10, nooelec nesdr mini 2 usb, it's rtl2832U
I've downloaded the zadig 2.4 drivers, initially I was getting 'connection terminated' all the time but I read about unchecking the hub part when installing and reinstalled the drivers and got further along.
I've ran dump1090 and it's found the rtl283, when I was first trying to run dump it would just load the page and stop.
Now I'm getting
Eggp169@185. Etc etc
Connecting
Connected via UDP (FD 1060)
Working
Ping 1
Syncing stream result 1
Ping 2
Syncing stream result 2
And it keeps going, any help much appreciated
Thanks and apologies if you keep getting threads like this, I have looked around and seem to have got a little further than 'connection terminated'
So I'm using win10, nooelec nesdr mini 2 usb, it's rtl2832U
I've downloaded the zadig 2.4 drivers, initially I was getting 'connection terminated' all the time but I read about unchecking the hub part when installing and reinstalled the drivers and got further along.
I've ran dump1090 and it's found the rtl283, when I was first trying to run dump it would just load the page and stop.
Now I'm getting
Eggp169@185. Etc etc
Connecting
Connected via UDP (FD 1060)
Working
Ping 1
Syncing stream result 1
Ping 2
Syncing stream result 2
And it keeps going, any help much appreciated
Thanks and apologies if you keep getting threads like this, I have looked around and seem to have got a little further than 'connection terminated'
Comment