Hi there,
Today I received my ADS-B dongle and ariel. Set up FR24 Feed on my Raspberry Pi. I have various challenges, including the IPv6 issue not allowing initial validation of my email address/location and the an error with DUMP1090 not working. I have, with the helpof this forum overcome all of these issues. I am now down to my last problem with MLAT. When I run sudo fr24feed-status I get the following:
[ ok ] FR24 Feeder/Decoder Process: running.
[ ok ] FR24 Stats Timestamp: 2018-09-15 07:41:34.
[ ok ] FR24 Link: connected [UDP].
[ ok ] FR24 Radar: T-YPPH91.
[ ok ] FR24 Tracked AC:.
[ ok ] Receiver: connected (0 MSGS/0 SYNC).
[FAIL] FR24 MLAT: not running ... failed!
I have stopped and started fr24feed and it occasionally works. But only brielfy when it does. I can use localhost and dump1090...gmap.html to view tracked aircraft when it does connect and occasionally it shows me online via the FR24 app on my iPad.
What have I done/missing to get MLAT working? I am fairly new to the Raspberry Pi so it could be something obvious!
Thank you in advance.
Richard.
Today I received my ADS-B dongle and ariel. Set up FR24 Feed on my Raspberry Pi. I have various challenges, including the IPv6 issue not allowing initial validation of my email address/location and the an error with DUMP1090 not working. I have, with the helpof this forum overcome all of these issues. I am now down to my last problem with MLAT. When I run sudo fr24feed-status I get the following:
[ ok ] FR24 Feeder/Decoder Process: running.
[ ok ] FR24 Stats Timestamp: 2018-09-15 07:41:34.
[ ok ] FR24 Link: connected [UDP].
[ ok ] FR24 Radar: T-YPPH91.
[ ok ] FR24 Tracked AC:.
[ ok ] Receiver: connected (0 MSGS/0 SYNC).
[FAIL] FR24 MLAT: not running ... failed!
I have stopped and started fr24feed and it occasionally works. But only brielfy when it does. I can use localhost and dump1090...gmap.html to view tracked aircraft when it does connect and occasionally it shows me online via the FR24 app on my iPad.
What have I done/missing to get MLAT working? I am fairly new to the Raspberry Pi so it could be something obvious!
Thank you in advance.
Richard.
Comment