No email after setup wizard

[Phil998]

I have added a feed to FR24 to my existing Pi running PiAware and Dump1090 using the wizard, or at least I have tried to! I entered my location and email address etc when requested and everything seemed to go OK. However, I have not received an email to enable me to link to my FR24 account and my status is showing OFFline. I double checked the email I entered and know it was correct and am showing a sharing key but no data. Any idea where to look? I assume I have gone wrong someware along the line but don't know where to start.

Thanks

Phil...

[Oblivian]

It will only activate once data is received.

Likely overrode the correct feed type (should be TCP source) and it cannot see any data.

Reconfigure using web configuration page on :8754 and check status there.

https://forum.flightradar24.com/showthread.php?p=74834

More than 4 contacts required at one time

Sent from my XT1092 using Tapatalk

[Phil998]

Hi, thanks for reply
:8745 shows receiver type as AVR (TCP), is this correct?

FR24 Status gives:

[ ok ] FR24 Feeder/Decoder Process: running.
[ ok ] FR24 Stats Timestamp: 2018-08-26 21:41:11.
[ ok ] FR24 Link: connected [UDP].
[ ok ] FR24 Radar: T-EGXC45.
[ ok ] FR24 Tracked AC:.
[FAIL] Receiver: down ... failed!
[FAIL] FR24 MLAT: not running ... failed!

Have reconfigured but same result??

Feed to FlightAware and 360Radar are running OK.

Running Pi 2B and USB dongle

Phil

[Oblivian]

What port for AVR - check the number of 0s as often entered wrong (30002)

Or do beast:30005

[Phil998]

Cheers, changed to beast:30005 and all working OK

Thanks

Phil