Tweet
I run a feeder FR24 with 1090-mutability in two location, the same setup.
One work flawlessly and updated fr24feed to 1.0.19-15 without a glitch (T-LIMJ5)
The other (T-LIMW3) present a lot of problems. It crashed self updating to 1.0.19, as many other experienced. But worst it sometime stop to work; the MyDataSharing page showed the feeder as "OnLine" last time it was out of service. When crash, it bring with him all the system, no possibility to connect via SSH non able to see the map. And the two feeder as very far one from the other, and sometime happens I am far for a month or so.
After removing power, I attached to a TV set and applied power again, just to be informed that a kernel panic prevented the system to go up.
I attach a picture of the screen.
My questions are: someone know why this happen?
I have the log disabled.
Thank to all
ciao
Roberto
One work flawlessly and updated fr24feed to 1.0.19-15 without a glitch (T-LIMJ5)
The other (T-LIMW3) present a lot of problems. It crashed self updating to 1.0.19, as many other experienced. But worst it sometime stop to work; the MyDataSharing page showed the feeder as "OnLine" last time it was out of service. When crash, it bring with him all the system, no possibility to connect via SSH non able to see the map. And the two feeder as very far one from the other, and sometime happens I am far for a month or so.
After removing power, I attached to a TV set and applied power again, just to be informed that a kernel panic prevented the system to go up.
I attach a picture of the screen.
My questions are: someone know why this happen?
I have the log disabled.
Thank to all
ciao
Roberto