After working smoothly for months I had to reboot my Raspberry Pi that ran FR24feeder. So, after booting up I ran into the well known Dump1090 errors mentioned in this forum (usb_claim_interface error -6 Error opening the RTLSDR device: Device or resource busy), resulting in my feed being connected to FR24 server but not sending any data.
This is because I have a manually installed version of dump1090-mutability 1.14 as well as the in-built dump1090 that comes with the installer package.
I followed Oblivian's well documented recommendations and changed FR24 Feeder "Receiver"-Settings from "DVB Stick (default)" to "AVR TCP" with a "Host/IP"-Setting" of "localhost:30002". This did the job and my feed was up again, sending data to FR24
But unfortunately from now on I can no longer see the DUMP1090-webpage with the map by entering http://<IP-address>:8080 into my browser, whereas the FR24 Feeder Status webpage at http://<IP-address>:8754 still works.
I still have the "--net" argument in the "Process arguments" section of "FR24 Feeder Settings" but when I enter http://<IP-address>:8080 there is no answer from the webserver.
Any suggestions what to do?
This is because I have a manually installed version of dump1090-mutability 1.14 as well as the in-built dump1090 that comes with the installer package.
I followed Oblivian's well documented recommendations and changed FR24 Feeder "Receiver"-Settings from "DVB Stick (default)" to "AVR TCP" with a "Host/IP"-Setting" of "localhost:30002". This did the job and my feed was up again, sending data to FR24
But unfortunately from now on I can no longer see the DUMP1090-webpage with the map by entering http://<IP-address>:8080 into my browser, whereas the FR24 Feeder Status webpage at http://<IP-address>:8754 still works.
I still have the "--net" argument in the "Process arguments" section of "FR24 Feeder Settings" but when I enter http://<IP-address>:8080 there is no answer from the webserver.
Any suggestions what to do?
Comment