Reinstalling feeder - feeder does not start

[Oernifly]

Hey there,

i am running my Raspberry 3B for more than a year in a row. Last month my SD card stopped working. I bought a new one and reinstalled the feeder software to the 8GB SD card...

the feeder does not start. Internet connection exists (Ping to FR24.com), Status of fr24feed: FR24 Feeder/Decoder Process...failed!

The feeder does not appear at flightradar.com/activate-raspberry-pi (There is only my offline Feeder from the old SD card).
So what are the steps to do a complete reinstall of the software to run the feeder under the same stream key again?

I dont know what to do...

[abcd567]

Copy paste output of following command

cat /etc/fr24feed.ini

NOTE:
For privacy reasons, remove value of fr24key from the post.

[Oblivian]

sudo fr24feed --signup

Use to be the way if it was successfully actually installed but not configured. (above will show that). If it works still remains to be seen

[Oernifly]

Thank you @Oblivian. This was the command i needed.

Where could i this command? I searched in forum, FAQs, Rpi "build your own" page of FR24...

now its working!

So thanks abcd567 too, but i think the log isn't neccessary anymore