Aircraft Tracked: 0

[st4ff]

I set up my receiver a few months ago and it has been working perfectly since day one. Today I noticed that my membership had been downgraded so I checked the FR24 Feeder Status, and it looks like below:

Flightradar24 Feeder/Decoder

Linux/generic/static_arm/1.0.18-9

Updated: 19:28:26 GMT+0800 (China Standard Time)

FR24 Link: Connected via UDP
FR24 Radar Code: T-VHST62
Aircraft Tracked (ModeS & ADS-B): 0
Aircraft Uploaded: N/A
Receiver: dvbt, Connected
MLAT running: NO

For some reason no aircraft are being tracked anymore. I am a total newbie at this and have no idea how to properly configure my receiver. I just followed the instructions on day one and it has been working flawlessly since -- until today. I haven't made any changes to the settings.


My setup:

DVB-T receiver connected to Raspberry Pi
Pi
fr24feed version: 1.0.18-9 (?)
Status of fr24feed window: See above
Config settings (Screenshot of config page): see below
Any visible startup errors (screenshot or paste): None that I know of
Additional software you may have running (or in the past): None that I know of
What checks have been performed to try and fix already: None -- I'm a total newbie at this

[Anmer]

Is your RPi communicating with your local network and Internet? Does your router see it connected?

Try a power reboot.

[st4ff]

Is your RPi communicating with your local network and Internet? Does your router see it connected?

Try a power reboot.

That did it -- thanks very much!

[mrcarlos]

delete the Screenshot because have your personal share key....
configure host with your computer ip address :30002
set the path with the dump1090 correct path.
cheers

Sent from my VKY-L09 using Tapatalk

[Oblivian]

Sharing key doesn't do much. If anyone was to try and use it to change your acct etc it needs to be cross referenced with the registered email address.

And the server will ignore any bad data not from a location registered within the receiver original location provided.