Hello everyone, I am a new user with the FR24 supplied hardware. Hooked it up, receiving the flashing red Mode S, and GPS signal. Plugged into a modem with CAT5 cable, which my PC is also connected to.
I've ran the fr24feed.exe as the DVB-T feed, but I keep getting:
2017-03-20 20:48:58 | [reader][i]Connecting to Generic receiver via (exe://mr-dump1090.exe --raw)
2017-03-20 20:48:58 | [reader][i]Connected to the receiver, configuring
2017-03-20 20:48:58 | [reader][i]Configured, processing messages
2017-03-20 20:48:58 | [reader][i]Connection terminated
over and over.
I am not exactly sure what dump1090 is. My feeder status is as follows:
FR24 Link: Connected via UDP
FR24 Radar Code: T-KVLD3
Aircraft Tracked (ModeS & ADS-B): 0
Aircraft Uploaded: N/A
Receiver: dvbt, Connected
MLAT running: N/A
I believe I may have a port blocking issue, or the software may be looking for dump1090. I'm stuck at this point and don't know where to go from here.
I've ran the fr24feed.exe as the DVB-T feed, but I keep getting:
2017-03-20 20:48:58 | [reader][i]Connecting to Generic receiver via (exe://mr-dump1090.exe --raw)
2017-03-20 20:48:58 | [reader][i]Connected to the receiver, configuring
2017-03-20 20:48:58 | [reader][i]Configured, processing messages
2017-03-20 20:48:58 | [reader][i]Connection terminated
over and over.
I am not exactly sure what dump1090 is. My feeder status is as follows:
FR24 Link: Connected via UDP
FR24 Radar Code: T-KVLD3
Aircraft Tracked (ModeS & ADS-B): 0
Aircraft Uploaded: N/A
Receiver: dvbt, Connected
MLAT running: N/A
I believe I may have a port blocking issue, or the software may be looking for dump1090. I'm stuck at this point and don't know where to go from here.
Comment