Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Micro ads-b connected to Raspberry Pi 3b

  1. #11
    Super Moderator
    Join Date
    May 2011
    Location
    T-NZCH1, PP:PH New Zealand
    Posts
    4,965
    Quote Originally Posted by sumec View Post
    Thanks!Workin now(use a USB stick from MicroADSB)The only issue now is MLAT not running but activated in settings
    .Is there a way to check what's wrong?Use raspian image,but have same issue on flightradar image

    i@raspberrypi:~ $ fr24feed-status
    [ ok ] FR24 Feeder/Decoder Process: running.
    [ ok ] FR24 Stats Timestamp: 2019-04-12 16:53:19.
    [ ok ] FR24 Link: connected [UDP].
    [ ok ] FR24 Radar: T-ENMS1.
    [ ok ] FR24 Tracked AC: 1.
    [ ok ] Receiver: connected (946 MSGS/0 SYNC).
    [FAIL] FR24 MLAT: not running ... failed!
    Depending on model Dip switch needs to be changed, This is for bullion

    Switch 2 - TimeTAG
    If this switch is ON, then a precise time code (for MLAT) will be generated
    by the decoder for each received frame. The adsbPIC-decoder time tag is
    based on a 12MHz clock. (Some other decoders/receivers use a 20 MHz
    clock instead)
    The adsbScope software via USB can activate the time tags by software. If
    this was done, then the decoder will send time tags even if the switch is in
    OFF position. The time tag can be used to triangulate aircraft position in
    collaboration with other decoders. If you don’t participate in such a network,
    then you should deactivate the time tags to reduce the load at the
    USB/WiFi-Interface.

    You also need more than 2-3+ contacts, I see you only have 1
    Posts not to be taken as official support representation - Just a helpful uploader who tinkers

  2. #12
    Passenger
    Join Date
    Apr 2019
    Posts
    2
    Do I get MLAT Failed-error if everything in setut is ok.but lack of sufficient contacts?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •