Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Before seeing your post above, has already solved it by following method:
First did this, but no success:
Error: Ignoring unknown...Last edited by abcd567; 2024-03-13, 17:32.
- Likes 1
Leave a comment:
-
As the total signal loss is product of loss per meter x length, even with a high loss cable like RG174, the total loss will be very small if coax length...
Leave a comment:
-
The coax cable of these antennas is generally low-cost RG174 which has high signal loss per meter.
Signals from distant aircraft are already weak....
Leave a comment:
-
If your output is large number lines with
sent number,number AC
(for example: sent 3,5 AC)
Then your system is receing...Last edited by abcd567; 2024-03-08, 18:54.
Leave a comment:
-
Try this command
Code:sudo journalctl -u fr24uat-feed | grep -w "AC"
If your system...
Leave a comment:
-
You can monitor summary of aircraft signals received and their decoded data sent to FR24 by following command
Code:sudo journalctl
Leave a comment:
-
It my be possible through docker.
Below is a 9 years old (2015) post. May give you some guidance:
Docker piaware - for rapid setup...
Leave a comment:
-
May be your dump978-fr24 is not producing any output due to bad dongle, or bad antenna cable connection, or wrong configuration. If your pi is tunning...Last edited by abcd567; 2024-03-07, 10:10.
Leave a comment:
-
What do you get from following command?
Code:sudo journalctl -u fr24uat-feed -n 25 | sed 's/ / /'
I have hardly 2 to...Last edited by abcd567; 2024-03-07, 05:26.
Leave a comment:
-
@paultcottey
Which uat decoder have you installed? Following are 3 most popular ones:
- dump978-fr24
- dump978-fa...
Leave a comment:
-
Did you try "purge-clean-fresh install" given below? This method is applicable to raspberry pi that is running either dump1090-fa or dump10...Last edited by abcd567; 2024-03-06, 17:04.
Leave a comment:
-
STEP-1: Purge & Clean
Code:sudo apt purge fr24feed sudo rm -rf /usr/lib/fr24 sudo apt clean
- Likes 1
Leave a comment:
-
After signup and restart, if you immediately run fr24feed-status command, it will show receiver failed. Wait at least 5 minutes after restart, and then...
Leave a comment:
-
Adding file "custom.toml" is latest version of Pi24 image (bookworm based) is NOT required.
The FR24 software developers have...
Leave a comment:
No activity results to display
Show More
Leave a comment: