Announcement
Collapse
No announcement yet.
best antenna
Collapse
X
-
Before I move to China , I never heard about VPN .
Even the broadband is 50MB downlink 5MB uplink , you don't own personal IP , so I purchase VPN personal IP service for Plant Plotter , to become a MLAT ground station and master user , bad bad bad news , I just found out I am the only Plant Plotter MLAT station in China .
Leave a comment:
-
Originally posted by iamnothere View PostA nightmare , to bypass the China GFW , I connect internet with full time VPN service . the trace route show package to FR24 server .
[ATTACH=CONFIG]6274[/ATTACH]
It's okay , because it can be much worth .
without VPN , package to FR24 server .
[ATTACH=CONFIG]6275[/ATTACH]
lost package 45% is normal , it can be up to 95% sometime .
Leave a comment:
-
Originally posted by iamnothere View Post@abcd567
Yes , just like the pic show . I still able picked up signal from the direction , it depends on the plant alt , Shanghai downtown is just like a concrete city , I stay here only because $ and save traffic time , I'd move far far away when I retired .
The jumping mostly happened while I use RTL1090 on Windows system , after I switch to dump1090 its getting much better I think , and the --ppm correction do help a lot .
Leave a comment:
-
A nightmare , to bypass the China GFW , I connect internet with full time VPN service . the trace route show package to FR24 server .
Screen Shot 2015-07-24 at 10.40.10 PM.jpg
It's okay , because it can be much worth .
without VPN , package to FR24 server .
Screen Shot 2015-07-24 at 10.41.27 PM.jpg
lost package 45% is normal , it can be up to 95% sometime .
Leave a comment:
-
@abcd567
Yes , just like the pic show . I still able picked up signal from the direction , it depends on the plant alt , Shanghai downtown is just like a concrete city , I stay here only because $ and save traffic time , I'd move far far away when I retired .
The jumping mostly happened while I use RTL1090 on Windows system , after I switch to dump1090 its getting much better I think , and the --ppm correction do help a lot .
Leave a comment:
-
@iamnothere:
Your situation is like shown in the diagram below. Are the planes jumping when passing behind the building?
Leave a comment:
-
@abcd567
Well , there do have a very tall building block one side of my view , my station alt is 137m , that building is like 280m or 300m I am not sure : (
Leave a comment:
-
@iamnothere:
Jumping is caused by tall buildings around antenna location. When the plane is at one side of tall building, your antenna gets signal. When plane goes behind building, signal disappears, plane looks stationary on map. When plane comes out from l behind tall building, signal again received, and plane on map suddenly jumps to new position.
To stop the jumping, you should raise your antenna above the height of nearby tall building. The antenna will then continously see the plane, and motion of plane on map will be smooth, not jumping.
Leave a comment:
-
At least 10 radarcape station in range of 300 nautical miles , some of station rare display on website .
My understanding is , all of the data collect and send to FR24 server , display on website or iPhone apps etc after selection , when people playing around the
apps they want to see the plant on smooth tracking line , they don't know who and maybe don't care who is feeding the data , only feeder care include myself .
I guess to fit FR24 needed , more hit rate seems more reasonable , not long range but jumping plant on display screen.
image show one of my host F-ZSSS1 half way to Korea Jeju island, sure there are much much more plant I pick up but no display .
Please forgive me my oddly English .
Screen Shot 2015-07-24 at 2.06.00 PM.jpg
Leave a comment:
-
Originally posted by Birdie View PostNo use !
If FR24 current method of data selection continues - it will frustrate any attempt to increase the range by improving the antenna system.
When the number of feeders in WSSS was only a few - I enjoyed seeing my extended range of coverage. As more and more F-feeders came online ( in Johore Bahru, Batam Island and Kuching ) - I even saw my range reduced to ZERO nm - i.e. not a single airplane displayed in FR24 site.
I have the best antenna system :
1). High Gain antenna
2). LNA ( hardly used )
3). Short LOW LOSS cable ( 5 metre )
4). FR 24 receiver
Regularly, i am not seeing ANY plane under my radar in FR24 - even though VRS showed 50 planes.
IMAGE 1
IMAGE 2
Leave a comment:
-
Originally posted by abcd567 View PostReducing/limiting the range will REDUCE the number of hits/positions reported.
If you want to increase the number of hits/positions reported, you should try to INCREASE the maximum range to its theoretical limit of 450 kms / 250 nm. This requires:
(1) Use higher gain antenna.
(2) Raise antenna above obstructions such as buildings, trees etc so that your antenna can "see" the horizon. Imagine your eye in place of the antenna, and if your eye can see the horizon, the antenna can also "see" the horizon. Once your antenna starts seeing horizon, no need to raise antenna any further.
(3) Use Amplifier between antenna & receiver.
(4) Set DVB-T's (or any other receiver's) gain to maximum, or better to AGC.
If FR24 current method of data selection continues - it will frustrate any attempt to increase the range by improving the antenna system.
When the number of feeders in WSSS was only a few - I enjoyed seeing my extended range of coverage. As more and more F-feeders came online ( in Johore Bahru, Batam Island and Kuching ) - I even saw my range reduced to ZERO nm - i.e. not a single airplane displayed in FR24 site.
I have the best antenna system :
1). High Gain antenna
2). LNA ( hardly used )
3). Short LOW LOSS cable ( 5 metre )
4). FR 24 receiver
Regularly, i am not seeing ANY plane under my radar in FR24 - even though VRS showed 50 planes.
Leave a comment:
-
Thanks , currently average covered up range from 230nm to 255nm , was hoping hit more plant if reduce and limited the range , must be a stupid idea : P
Leave a comment:
-
Originally posted by iamnothere View Postfeed_stats
[ATTACH=CONFIG]6272[/ATTACH]
If you want to increase the number of hits/positions reported, you should try to INCREASE the maximum range to its theoretical limit of 450 kms / 250 nm. This requires:
(1) Use higher gain antenna.
(2) Raise antenna above obstructions such as buildings, trees etc so that your antenna can "see" the horizon. Imagine your eye in place of the antenna, and if your eye can see the horizon, the antenna can also "see" the horizon. Once your antenna starts seeing horizon, no need to raise antenna any further.
(3) Use Amplifier between antenna & receiver.
(4) Set DVB-T's (or any other receiver's) gain to maximum, or better to AGC.Last edited by abcd567; 2015-07-23, 17:33.
Leave a comment:
Leave a comment: