Hi folks,
I have the active antenna (outside) and Bias-Tee from Jetvision
I have had some problems where the antenna would work on and off, and my Raspberry reported overcurrent for the USB-Port of the Bias Tee
Then I plugged it to a 5V 1.3Amp supply and it ran again for about 12h, then it required an even more powerful USB supply.
The range of the antenna and reception quality has not changed at all
What is happening with my setup?
Is the Bias-Tee dying and struggling to supply the power to the antenna, or is the antenna somehow damaged (rain) and requiring an insane amount of power?
I hope you can help me.
Thank you very much!
I have the active antenna (outside) and Bias-Tee from Jetvision
I have had some problems where the antenna would work on and off, and my Raspberry reported overcurrent for the USB-Port of the Bias Tee
Then I plugged it to a 5V 1.3Amp supply and it ran again for about 12h, then it required an even more powerful USB supply.
The range of the antenna and reception quality has not changed at all
What is happening with my setup?
Is the Bias-Tee dying and struggling to supply the power to the antenna, or is the antenna somehow damaged (rain) and requiring an insane amount of power?
I hope you can help me.
Thank you very much!
Comment