Announcement

Collapse
No announcement yet.

QUICK SPIDER - No Soldering, No Connector

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • abcd567
    replied
    ENHANCEMENT FOR OUTDOOR USE
    1) Apply a rapid setting (5 minutes) sealant like 2-part epoxy, or silicone, or hot melt glue, or similar at the point where radials enter the outer jacket of coax.
    2) After installation. wrap the F-connector in tape to prevent moisture ingress. You may also use outdoor type F connector which are water resistant


    Last edited by abcd567; 2016-10-27, 00:16.

    Leave a comment:


  • abcd567
    started a topic QUICK SPIDER - No Soldering, No Connector

    QUICK SPIDER - No Soldering, No Connector

    DIY QUICK SPIDER - No Soldering Required, No SO239 Connector Required

    Maximum Range Curve By VRS

    Hardware Used for Range Curve Plotting:
    Quick Spider >> 12 ft / 4 m RG6 Coax >> Generic DVB-T (black) >> Orange Pi PC





    Trial Run - Indoor Near Large Window





    HOW TO MAKE

    Please see these posts also for previous Versions:

    (1) May 2015

    (2) September 2016




    STEP 1 - Stuff Required





    STEP 2 - Cut Coax Into Required Pieces





    STEP 3 - Remove braid & Insulation





    STEP 4 - Bend Wires





    STEP 5 - Assemble Radials





    STEP 6 - Bend Down Radials 45 Degrees


    .
    Last edited by abcd567; 2016-11-22, 18:57.
Working...
X