Hello to everyone.
i'm Luca and i'm writing from Pisa , italy.
today i received FR24 box to become a Flightradar24 host.
i mounted the antenna on my ham tower and i connected the Gps and the ethernet cable to my ADSL router.
i downloaded the Flighradar24 program and started to receive...
with a big surprise i t didn't work.
the program screen shot gives to me these informations:
Alias:N/A
Position:N43.849 E10.450
GND: YES Mode S : NO
Protocol Tcp
Basestation : Error
Network :OFF
Info : No aircraft , at least 2 required
TX/AC Loss : 0.0%/0.0%
LED on the radar box:
POWER : green always on
Mode S : blonking high speed red
GPS : blinking green
if i disconnect the Mode-S antenna back to the FR24 box the LED starts to blink slowly in red....if i make the same under the antenna ( type N connector ) the LED light makes the same.
so it means that the RF low loss cable is full workin'.
i don't know why it doesn't work
can anyone halps to me?
many tks to everyone
i'm Luca and i'm writing from Pisa , italy.
today i received FR24 box to become a Flightradar24 host.
i mounted the antenna on my ham tower and i connected the Gps and the ethernet cable to my ADSL router.
i downloaded the Flighradar24 program and started to receive...
with a big surprise i t didn't work.
the program screen shot gives to me these informations:
Alias:N/A
Position:N43.849 E10.450
GND: YES Mode S : NO
Protocol Tcp
Basestation : Error
Network :OFF
Info : No aircraft , at least 2 required
TX/AC Loss : 0.0%/0.0%
LED on the radar box:
POWER : green always on
Mode S : blonking high speed red
GPS : blinking green
if i disconnect the Mode-S antenna back to the FR24 box the LED starts to blink slowly in red....if i make the same under the antenna ( type N connector ) the LED light makes the same.
so it means that the RF low loss cable is full workin'.
i don't know why it doesn't work
can anyone halps to me?
many tks to everyone
Comment