I'm a new feeder since 2 weeks.
My hardware is RasPi 3B+ with DVB-t stick and a DIY J-beam antenna.
I just discovered the <myIP>/dump1090/gmap.html that shows only planes around my DVB-t stick.
Wonderfull except I do not see "site position and range rings" as overlay while the planes are plotted.
It would be great to see the range rings and position on this local map,
I searched the forum but did not find the answer/solution
I hope someone can help me ?
fr24feed-status tells me:
FR24 Feeder/Decoder Process: running.
FR24 Stats Timestamp:2025-06-07 18:34:54
FR24 Link: connected [UDP].
FR24 Radar: T-EHW0152
FR24 Tracked AC: 36.
Receiver: connected (24460 MSGS/0 SYNC).
FR24 MLAT: not running . . . failed!
MLAT . . . failed while I activated it in <myIP>:8754/settings.html , I do not know if this is related to "site position and range rings".
My hardware is RasPi 3B+ with DVB-t stick and a DIY J-beam antenna.
I just discovered the <myIP>/dump1090/gmap.html that shows only planes around my DVB-t stick.
Wonderfull except I do not see "site position and range rings" as overlay while the planes are plotted.
It would be great to see the range rings and position on this local map,
I searched the forum but did not find the answer/solution
I hope someone can help me ?
fr24feed-status tells me:
FR24 Feeder/Decoder Process: running.
FR24 Stats Timestamp:2025-06-07 18:34:54
FR24 Link: connected [UDP].
FR24 Radar: T-EHW0152
FR24 Tracked AC: 36.
Receiver: connected (24460 MSGS/0 SYNC).
FR24 MLAT: not running . . . failed!
MLAT . . . failed while I activated it in <myIP>:8754/settings.html , I do not know if this is related to "site position and range rings".
Comment