No announcement yet.

How to Install dump1090-mutability_1.15~dev on RPi

  • Filter
  • Time
  • Show
Clear All
new posts

  • Originally posted by wiedehopf View Post

    Note you can't have dump1090-fa and dump1090-mutability installed at the same time.
    The script will therefore deinstall dump1090-mutability.
    Great!! This forum is back on line - how could we live without it!

    I've just done a complete reinstall.
    I do like dump1090-mutability_1-15 with all the additions like Heywhatsthat range circles, colo(u)red rings and embedded gain changing etc.
    The new performance graphs are excellent also.
    I then installed dump1090-fa and that too has many features that I like. so I hoped to be able to run both versions but I find that the dump1090-mutability_1-15 map has now lost all the installed features.It just runs with a basic layout and grey (gray) aircraft.
    Then I saw your post saying that It isn't possible to install both but I'm sure that I had successfully done that before I decided to begin with a new USB stick.
    Is is definitely not possible to have both versions?



    • Well you can have both versions of the web interface, having both dump1090-mutability and dump1090-fa is another story.

      Just go with this bundle here, it has multiple web interfaces:


      • Yes I have already gone with that and I do like the interface. I just miss the set gain capability, the option of more range circles and the Heywhatsthat radio horizon plot


        • You can change that via the configuration just as with the other interface.
          You can also add the upintheair.json

          Also as previously said there are multiple interfaces.
          The tar1090 interface config is configured like this:

          Same html folder is where uptintheair.json goes.


          • Thanks again, I've now got both the tar1090 and the dump1090-fa maps with colo(u)red and blue dotted range lines out to 300nm, the upintheair theoretical coverage area and the Bing maps all as I want them.
            I would like to get back the ability to set receiver gain from the map views perhaps by changing the paths in the various abcd567's instructions on that subject. would that work? Anyway it's past 1 am over here now so I'm giving up for tonight.



            • I wouldn't recommend it, you are on your own with that.
              It's not like it's complicated to change gain via command line:
              That's already included.

              Note you should then disable the automatic algorithm for changing gain.


              • Just a quick note for abcd567

                Just used your excellent instructions (again!!) on How to Install dump1090-mutability_1.15~dev on RPi and spotted a tiny typo in the add RSSI column section.


                2.1 - Prepration

                Unless that's the Canadian spelling!!!