Feed data to Flightradar24 and FlightAware simultaneously using FlightAware Feeder

[KOM20]

Feed data to Flightradar24 and FlightAware simultaneously using FlightAware Receiver

Follow the steps below...

Configuring Flightaware =>

Step 1: Go to http://flightaware.com/adsb/register
Step 2: Select ur feeder type.Input your coordinates and on you feeder you will see 4 Digit code.
Step 3: Click Register.

izqiUx1.png

Thats it Flightaware is configured !!

Configuring Flightradar24 =>

Step 1. Download FR24 software (http://feed.flightradar24.com/#windows)
Step 2. Sign up for an account during setup. If you already have a sharing then enter that after entering your email address.
Step 3. During receiver selection select AVR Compatible (DVBT over network, etc) option.
Step 4. In connection type select Network connection.
Step 5. Next it will ask you for receiver's IP, enter that.
Step 6. After that it will ask you for a port number, enter 30002 there.
Rest of the options are up to you as you need them.

Thats it Flighradar24 is configured on Flightaware Receiver !!

Wait atleast 24 hrs before stats start appearing on both website

Enjoy

Note: Flightware does allow sharing data to other sites according to their policy.
Visit http://flightaware.com/adsb/faq FlightFeeder Section to read it.

[huebi77]

Hi,

is this working out of the receiver?
I want to run a system without a pc or raspberry for sharing data.

Best regards,
Marcus

[dijugar2@gmail.com]

Hello Huebi77.

Do you have the solution for this question? I also want to share data without a permanent connection to the internet from a PC.
Regards.

[pdx97236]

I'm also having issues adding the second feed

[sarry886]

I'm also having issues adding the second feed

Did you guys get an answer to that?

[wiedehopf]

You can't feed FR24 from a FlightFeeder (provided by Flightaware) directly.

You need an independent Raspberry, there install fr24feed and select protocol Beast TCP with port 30005 and the IP address of the FlightFeeder.

Note that if you are just using the piaware sd-card, it's not a problem to run fr24feed.
Choose protocol Beast TCP, the host is 127.0.0.1 and the port 30005.

If you choose DVB-T it will mess up your piaware installation.
(if you have already have messed up the installation and don't want to start fresh, you can use this script to fix it: https://github.com/wiedehopf/adsb-sc...or-dump1090-fa)