new reciver, suddenly no data upload

[ftfmax]

Hey Guy's,

i've just set up a RP3B with the Image from FR24, and it works after setting up the wifi correct .
The Raspi was seen in the Reciver list, no Problem so far.

After that i installed "tar1090" for seeing the recived data in my home network. this works fine.
Then i saw, that my reciver isn't listed anymore, but when i look at my local interface there is no error.

I tried the instructions on the page when the reciver isn't showed, this won't work, i also tried the manual from the forum with the ini file.

I can't find any error in the logs from the fr24 interface. And Data must be ok cause tar1090 displaying planes.

the only thinig i can say, that the settings in the fr24 software automaticaly changed from dvbt to modes beast (tcp) from itself after installing tat1090.

any suggestions?
thanks max

[wiedehopf]

dvb-t mode means that fr24feed itself grabs the SDR. (but doesn't provide data / uses an outdated decoder)

Thus when you install readsb, it grabs the SDR and reconfigures fr24feed to use the decoded data.
It seems fr24feed is being especially unreliable in recent versions as quite a few people have issues setting it up in a very basic configuration.

[ftfmax]

dvb-t mode means that fr24feed itself grabs the SDR. (but doesn't provide data / uses an outdated decoder)

Thus when you install readsb, it grabs the SDR and reconfigures fr24feed to use the decoded data.
It seems fr24feed is being especially unreliable in recent versions as quite a few people have issues setting it up in a very basic configuration.

maybe fr24 doesn't like shareing? i just set up everything new, and the same problem... in the webinterface everything ok, on the page none. but readsb works...

[abcd567]

Sometimes debugging the problem is hard.
In such cases a fresh install (i.e. re-writing the image) is an easier solution.

[wiedehopf]

Try this, it's usually very easy to use: https://adsb.im

Or i have a guide for custom installs as well, should allow you to check the fr24feed logs https://github.com/wiedehopf/adsb-wi...ADS-B-receiver