[FAIL] Receiver: down... faild!

[orivoll]

Hello,

My status on data sharing is online but it seems that my raspberry doesn't recognize the ADS-B USB dongle and when I run fr24feed-status on PuTTY I get the below output:

PוTTY output.jpg

I tried all 4 USB ports on my raspberry and restarted it few times, but still nothing.
When I connected the dongle to my laptop it's recognized, but the raspberry doesn't.

If someone has seen such an issue before and has an idea on how to fix it - bless him!

Thanks in advance!

[abcd567]

You should tell what OS image and software you have installed on RPi.

Please give following commands, and post output of the last command

sudo apt install rtl-sdr

sudo systemctl stop fr24feed  dump1090-mutability dump1090-fa  

rtl_test -t

[orivoll]

You should tell what OS image and software you have installed on RPi.

Please give following commands, and post output of the last command

sudo apt install rtl-sdr

sudo systemctl stop fr24feed dump1090-mutability dump1090-fa

rtl_test -t

Thanks for your reply.
I understand almost nothing about this device and just followed the instructions of FR24

PuTTY output 18.12.2021-1.jpg

[Oblivian]

There's the issue

Wrong tuner.
FC0012 is not capable of ADSB.

https://forum.flightradar24.com/forum/radar-forums/flightradar24-feeding-data-to-flightradar24/11828-adsb-sdr-usb-tv-stick-dongle-requirements

[abcd567]

As Oblivian has already said, wrong tuner chip Fitipower FC0012.

Get a dongle with 820T or 820T2 tuner chip.

20211218_123915.jpg

[orivoll]

Thank you all for the help!
I need to purchase another dongle....

[orivoll]

Well, it's been a while and I have finally purchased another dongel which is supposed to have 820T2 tuner chip.
But still not working.
Will appreciate any help here.
Thanks a lot!

PuTTY output 20.4.2022.jpg

[wiedehopf]

Well it's not a R820T2 tuner, it's a R828D tuner.

I have no clue about the R828D and if it works for 1090 MHz.

It would help getting some graphs from graphs1090 and log output from readsb: https://github.com/wiedehopf/adsb-wi...ADS-B-receiver
The fr24feed status output is very limited.
So ... if you want to poke around some, get readsb / graphs1090 from the link above and then get the log for readsb as it's described on the install page for readsb linked in the guide.

[Oblivian]

I couldn't find anything definite either. Other than same frequency range on paper. But has 3 input filters to clear up actual tv frequencies. Which may have detrimental impact.

[orivoll]

Thanks guys!
It will be more easy for me to purchase a new dongle but this time to make sure it's the right one.
I would appreciate if you can recommend about a specific one.