Announcement

Collapse
No announcement yet.

Need help setting up my raspi

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Need help setting up my raspi

    Hello,

    now i tried for about 10h to setup my raspi for FR24 and Flightaware. My last attempt was this manual:

    https://forum.flightradar24.com/foru...137#post132137

    Flightaware seems running just fine, but FR24 says "Online - No Data"

    This is my output from fr24feed-status

    Code:
    [ ok ] FR24 Feeder/Decoder Process: running.
    [ ok ] FR24 Stats Timestamp: 2020-09-22 18:24:47.
    [ ok ] FR24 Link: connected [UDP].
    [ ok ] FR24 Radar: T-LOWL232.
    [ ok ] FR24 Tracked AC: 0.
    [FAIL] Receiver: down ... failed!
    [FAIL] FR24 MLAT: not running ... failed!
    Do you have any suggestions how to get it running properly?

  • #2
    What are you getting if you web page into that pi on port 8754?

    Comment


    • #3
      https://github.com/wiedehopf/adsb-wi...ADS-B-receiver

      Comment


      • #4
        Please please go easy on me as I'm new to all this RPI stuff.
        I've set up a PI with FR24 feed on Wifi and all ok
        FR24 feed is starting and can check through 8754 status page.
        Can log into Dump1090 and see a map
        MLAT is running OK
        The only problem is that it never picks up any aircraft
        I believe the dongle is not compatible.
        I've run a test and attached it below.
        Any help would be great.
        dongle.png

        Many thanks

        Mark

        Comment


        • #5
          As I see your device is busy. If you want to run the test you should stop fr24feed service before:
          Code:
          sudo service fr24feed stop
          Now you can run the test:
          Code:
          rtl_test -t
          After all remember to rerun fr24feed:
          Code:
          sudo service fr24feed start

          Comment


          • #6
            I did say I was new but many thanks.
            Below is another test result.
            Thanks in advance



            Dongle.jpg

            Comment


            • #7
              Your hunch was right
              Fitpower FC00012

              Not Rafael 820T/T2

              https://forum.flightradar24.com/foru...e-requirements
              Posts not to be taken as official support representation - Just a helpful uploader who tinkers

              Comment


              • #8
                As said many thanks, I have just ordered a new one that the seller guarantees will be right.

                Mark

                Comment

                Working...
                X