Hi folks.
Finally managed to have my Raspberry Pi feeding into FR24 but I have a wee query.
My Pi2 runs on a Flightaware Dongle and shows the following in the Flightaware statistics - Multilateration (MLAT): Supported / Enabled (synchronized with 145 nearby receivers) but when I look at my FR24 Feeder Status, it shows MLAT running - NO
In FR24 Feeder Status page, if I click on Restart Software, the MLAT Running changes to YES
Am I missing a setting somewhere for the MLAT software to automatically start? I've checked the settings page and MLAT is set to YES to participate in MLAT Calculations but not sure if this is the 'switch' to run the software and participate.
Any assistance greatly appreciated
Declan
Finally managed to have my Raspberry Pi feeding into FR24 but I have a wee query.
My Pi2 runs on a Flightaware Dongle and shows the following in the Flightaware statistics - Multilateration (MLAT): Supported / Enabled (synchronized with 145 nearby receivers) but when I look at my FR24 Feeder Status, it shows MLAT running - NO
In FR24 Feeder Status page, if I click on Restart Software, the MLAT Running changes to YES
Am I missing a setting somewhere for the MLAT software to automatically start? I've checked the settings page and MLAT is set to YES to participate in MLAT Calculations but not sure if this is the 'switch' to run the software and participate.
Any assistance greatly appreciated
Declan
Comment