Originally posted by Farsouthscanner
View Post
Announcement
Collapse
No announcement yet.
Trying to configure MicroADSB on Pi24
Collapse
X
-
-
Thank you Oblivian
I changed it to /dev/ttyACM0 and the command line now says OK beside Receiver Connected.
Just have to wait for a plane to go over and confirm it is working.
Thanks again
Leave a comment:
-
If however, Miro changed the way the sticks work. And it is stuck outputting pre-decoded data on 30002. You may be out of luck.
The current feeder can't understand AVR data. Only beast it seems
Leave a comment:
-
No, Dump1090 is NOT used on microadsb.
Dev/serial is wrong
The default example it shows before changing it would have been the correct one.
See the how to find and correct settings here
Feel free to post/discuss suggestions here http://forum.flightradar24.com/threa...4840#post74840 (http://forum.flightradar24.com/threads/9875-Info-Updates-Ammendments-Placeholder?p=74840#post74840) This guide is not to be taken as officially sourced support information. It is contributor-made Information has been repeated many
Leave a comment:
-
Trying to configure MicroADSB on Pi24
Hi all
I am trying to migrate to Pi24, I have read a lot of posts here but most of it is too technical.
I have the account set up but not seeing any aircraft being tracked.
I am wondering if I need to use Dump1090 with my receiver. One forum post here says that sometimes the MicroADSB USB receiver is a DVB-T one.
My receiver is this one from microadsb.com
The status page for my pi24 install is this
The settings page is
The command line in Pi24 has
When I was using this receiver in Plane Plotter it was set to an AVR receiver. In Pi24 I ahve tried the MicroADSB option first then AVR, I could be doing something wrong but neither of those seemed to work.
Any help would be appreciated
MarkTags: None
Leave a comment: