Announcement

Collapse
No announcement yet.

Trying to configure MicroADSB on Pi24

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Trying to configure MicroADSB on Pi24

    Hi all
    I am trying to migrate to Pi24, I have read a lot of posts here but most of it is too technical.
    I have the account set up but not seeing any aircraft being tracked.
    I am wondering if I need to use Dump1090 with my receiver. One forum post here says that sometimes the MicroADSB USB receiver is a DVB-T one.
    My receiver is this one from microadsb.com
    https://www.dropbox.com/s/mma6gkb2l0...eiver.jpg?dl=0

    The status page for my pi24 install is this
    https://www.dropbox.com/s/df3pbifdbu...tatus.jpg?dl=0

    The settings page is
    https://www.dropbox.com/s/y2k8ga987c...tings.jpg?dl=0

    The command line in Pi24 has
    https://www.dropbox.com/s/fcgqb7lnow...0Pi24.jpg?dl=0

    When I was using this receiver in Plane Plotter it was set to an AVR receiver. In Pi24 I ahve tried the MicroADSB option first then AVR, I could be doing something wrong but neither of those seemed to work.
    Any help would be appreciated
    Mark

  • #2
    No, Dump1090 is NOT used on microadsb.

    Dev/serial is wrong

    The default example it shows before changing it would have been the correct one.

    See the how to find and correct settings here

    https://forum.flightradar24.com/thre...ll=1#post85177
    Posts not to be taken as official support representation - Just a helpful uploader who tinkers

    Comment


    • #3
      If however, Miro changed the way the sticks work. And it is stuck outputting pre-decoded data on 30002. You may be out of luck.

      The current feeder can't understand AVR data. Only beast it seems
      Posts not to be taken as official support representation - Just a helpful uploader who tinkers

      Comment


      • #4
        Thank you Oblivian
        I changed it to /dev/ttyACM0 and the command line now says OK beside Receiver Connected.
        Just have to wait for a plane to go over and confirm it is working.
        Thanks again

        Comment


        • #5
          Originally posted by Farsouthscanner View Post
          Thank you Oblivian
          Just have to wait for a plane to go over and confirm it is working.
          Thanks again
          Confirming now its working, thanks for the help Oblivian, saved me a large amount of stress.

          Comment

          Working...
          X