No announcement yet.

What am I doing wrong? trying to get fr24 img up and running

  • Filter
  • Time
  • Show
Clear All
new posts

  • What am I doing wrong? trying to get fr24 img up and running

    UP front... apologies.. I'm clueless here! Only exposure before this was the standard flightaware image which I never tweaked.

    I've built a fresh install onto SD card using the fr24 image. It's up and running to a point, but 1090dump is NOT running.

    When I visit http//myip:8754 this is what I'm seeing:
    FR24 Link: Connected via UDP
    FR24 Radar Code: T-EGPH192
    Local IP(s):
    Aircraft Tracked:
    (ModeS & ADS-B) 0
    Aircraft Uploaded: N/A
    Receiver: beast-tcp, Connected
    MLAT running: NO
    Settings behind that are:
    Receiver: ModeS Beast TCP
    Baudrate: default
    When I visit my dump1090 page. the map shows the following error message:
    Problem fetching data from dump1090.
    AJAX call failed (error: Not Found). Maybe dump1090 is no longer running?
    The displayed map data will be out of date.
    I've installed it afresh a couple of times... but am at a loss as to where I've messed up! I've got SSH ok...


  • #2
    Try this:


    • #3
      Worked in a flash!! Many thanks!