No announcement yet.

Looking for instructions on how to upgrade dual feeds to FR24 & FA

  • Filter
  • Time
  • Show
Clear All
new posts

  • Looking for instructions on how to upgrade dual feeds to FR24 & FA

    Iíve been feeding to FA & FR24 for a few years now. For whatever reason, my FR24 feed has died. It used to die about once every few months and all I needed to do was re-boot the R-Pi and all would be fine again. Now, nothing. My FA feed still works fine but FR24 wonít come back up.

    Does anyone have some instructions on how to install the latest software so that I can run both again? Itís been so long since I installed the 1st one, I do not recall how I did it.



  • #2
    They auto update

    If you installed Dump1090 on its own, or FA first. Just change the FR settings to beast-TCP:30005. Chances are it is on AVR-TCP:30002 which has stopped working on the later version
    Posts not to be taken as official support representation - Just a helpful uploader who tinkers


    • #3

      Raspberry Pi:How To Install Raspian OS + Dump1090 + FR24 Data Feeder


      • #4
        Thanks for the assistance. I had quick success going with Option 4. However, the password on my R-Pi seems to have changed. Any idea on what the default might be? When I use Putty to SSH into it, I can't get past the dang password now.

        Small steps are good.


        • #5
          SSH needs to be enabled by placing a file named ssh on the boot partition.
          The password/user is in the quote below (applicable for the piaware sd-card image)

          Change device password

          Your PiAware device is on the Internet, so although it is likely behind your home router (NAT), it is still a good idea to change the pi user's password from the default password (flightaware).

          Login to the device with the username "pi" and password "flightaware".
          Type "passwd" and follow the instructions to change the password for the account.
          Enable SSH access

          For security reasons, SSH access is disabled by default on new PiAware SD card installs, starting with version 3.3. To enable SSH, create an empty file on the /boot partition of the SD card with the filename of "ssh" only (no file extension). When this file is present, SSH will be automatically enabled.


          • #6

            Piaware image
            username = pi
            password = flightaware