Announcement

Collapse
No announcement yet.

Raspberry Pi 3 B+ and USB Dongle R820T2 no flights recognized

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • wiedehopf
    replied
    Looks like the coverage increased a bit for that area

    Leave a comment:


  • Nomax2000
    replied
    Today the new antenna and receiver arrived in Addis. My reception is much better now.

    Bildschirmfoto 2019-04-23 um 18.56.37.jpg

    After a few hours.

    Additional I got today the package of Flightradar24. Now I am receiving data from two devices.

    Leave a comment:


  • wiedehopf
    replied
    It's above sea level.

    If you try putting in lower than local altitude into the yellow box it will show an error.

    Good luck then with the new antenna!

    Leave a comment:


  • Nomax2000
    replied
    Is it the hight of the planes above sea level oder ground? because I am living already on 8000ft. The airport Addis Ababa is officially on 7657ft. If it is 10000ft above sea level I should see them landing.
    I tried it with 10000/30000ft and 10000/45000ft.
    IMG_0081.jpg
    IMG_0082.jpg

    Leave a comment:


  • wiedehopf
    replied
    Originally posted by Nomax2000 View Post
    Because of the Ethiopian Highland and the Mountains it’s not easy. But I shall see the landing planes.
    Note that the default outlines are for 10000 ft and 30000 ft, so for the landing planes you would need to change that number.

    But as you said if you can see them with your eyes the antenna should be able to pick them up.
    I'm actually surprised your current antenna didn't pick them up as the signal should be strong as they are close by.

    Leave a comment:


  • Nomax2000
    replied
    Because of the Ethiopian Highland and the Mountains it’s not easy. But I shall see the landing planes.

    Leave a comment:


  • wiedehopf
    replied
    Have you created a panorama like this:

    https://forum.flightradar24.com/thre...ange-I-can-Get

    The outline should tell you if the airplanes coming into the airport are even in your view.

    If your terrain is unfavorable and the planes come in on tracks that are obscured, no amount of reception equipment will help.

    Anyway good luck with the new antenna and receiver.

    Leave a comment:


  • Nomax2000
    replied
    My reception is still bad. Even after I put the antenna on the roof. I ordered now a FlightAware pro plus stick and a bigger outdoor antenna.
    No tracks and only one uploaded plane.

    Leave a comment:


  • Oblivian
    replied
    Originally posted by wiedehopf View Post
    And thank you Oblivian for unlocking the posts
    At 4am. I don't think so. It was multiple quotes and @s. 2nd text only attempts worked

    Sent from my EML-L09 using Tapatalk

    Leave a comment:


  • Nomax2000
    replied
    First of all thank you very much for your support and patience.

    The airport isn't far away, maybe 5km. But Addis is very mountainous.

    Many planes are arriving and leaving in the evening. I will see what's happening tonight.

    Leave a comment:


  • wiedehopf
    replied
    Maybe check this thread:

    https://forum.flightradar24.com/thre...ange-I-can-Get

    Note that this is only valid if you don't have other houses that are in the way.
    There aren't many aircraft so maybe just let it run and check your feed statistics on fr24 tomorrow?

    Planes on the ground are hard to receive unless you are very close to the airport.

    Leave a comment:


  • Nomax2000
    replied
    I changed my setup. The raspberry is now quite far away from other electronic devices. Unfortunately the cable of the antenna isn't long enough to put it on the roof. I will try some different locations. But the changes will be small.

    Right now there are some planes on the ground and one is 100km away.

    Leave a comment:


  • abcd567
    replied
    Originally posted by wiedehopf View Post
    If you can see them then you should be receiving them easily.
    The map can be changed like this: https://forum.flightradar24.com/thre...uot-Water-Mark
    @abcd567 that thread can probably also use the remount command
    I dont understand the logic of FR24 developers who made PI24 file system "read-only".

    Thanks for suggesting inclusion of mount/remount command in Map thread.
    Since this problem has became known to me before I created the Map post in February 2019, I ensured to included mount/remount command (Step-2).

    Leave a comment:


  • wiedehopf
    replied
    The tip needs to point up. Also the further the antenna can "look" the better. So having it on a roof or an elevated position is very beneficial.

    Can you check flightradar24 if there are even close by aircraft at the moment?
    Last edited by wiedehopf; 2019-04-10, 18:18.

    Leave a comment:


  • Nomax2000
    replied
    Yes, the list is working but empty.
    It was a complete package for the raspberry pi 3 b+ with an 3A power supply.

    Is the direction of the antenna important?

    Leave a comment:

Working...
X