Hi there,
Newbie question on setting up a feeder.
I created the SD card and tried to register an RPi3 feeder to my account.
After powering up and waiting for a while the feeder was not listed on the "Activate New Receiver" webpage.
So, I tried the "If your receiver is not in the list above please follow the instructions here" link and ran the script it recommended via SSH.
The script runs, but after a while it fails and displays the following message:
gpg: keyserver receive failed: Cannot assign requested address
Note that I am not overly proficient with linux/raspian etc. so appreciate any help suggestions be somewhat simplistic.
Thanks in advance !
Newbie question on setting up a feeder.
I created the SD card and tried to register an RPi3 feeder to my account.
After powering up and waiting for a while the feeder was not listed on the "Activate New Receiver" webpage.
So, I tried the "If your receiver is not in the list above please follow the instructions here" link and ran the script it recommended via SSH.
The script runs, but after a while it fails and displays the following message:
gpg: keyserver receive failed: Cannot assign requested address
Note that I am not overly proficient with linux/raspian etc. so appreciate any help suggestions be somewhat simplistic.
Thanks in advance !
Comment