Tweet
I recently purchased a NooElec NESDR Mini 2 and went through the setup procedures and everything seemed to be working fine. I installed the driver for the usb without an issue but when I went to start up fr24feed.exe after doing the initial setup it was giving connection terminated message. I shut down the program completely and check in my processes to make sure it still wasn't working and tried it again. Same thing with the connection terminated messages. So I tried again running it as admin but still got the same message. What should the device show up as in device manager once it has the correct driver installed and what category should it be under on windows 10.
Code:
[main][i]FR24 Feeder/Decoder [main][i]Version: 1.0.19-15/generic [main][i]Built on Feb 6 2018 10:20:41 (???/Windows/i386) [main][i]Running on: Windows10.0 [main][i]Local IP(s): [main][i]Copyright 2012-2018 Flightradar24 AB [main][i]Took this line out because i was getting an error message about posting links [main][i]Reader thread started [reader][i]Initializing reader [time][i]Synchronizing time via NTP [httpd][i]Server started, listening on 0.0.0.0:8754 [master][i]Starting processing thread [reader][i]Connecting to DVBT receiver via (exe://mr-dump1090.exe --raw) [reader][i]Connected to the receiver, configuring [reader][i]Configured, processing messages [reader][i]Connection terminated [time][i]Time synchronized correctly, offset +1.0057 seconds [main][i]Feed Network client started [main][i]RAW data server started [feed][i]Downloading configuration [raw][i]Initializing server [raw][i]Starting server on 0.0.0.0:30002 [feed][c]Interval: 5s [feed][c]Latitude: 42.1630 [feed][c]Longitude: -76.8959 [feed][c]GND: YES [feed][c]NonADSB: YES [feed][c]Timestamps: optional [feed][c]Max range AIR: 350.0nm [feed][c]Max range GND: 100.0nm [feed][i]defined 4 servers [stats][i]Stats thread started [feed][n]KELM1@185.218.24.22:8099/UDP [feed][n]connecting [feed][n]connected via UDP (fd 920) [feed][n]working [reader][i]Connecting to DVBT receiver via (exe://mr-dump1090.exe --raw) [reader][i]Connected to the receiver, configuring [reader][i]Configured, processing messages [reader][i]Connection terminated [reader][i]Connecting to DVBT receiver via (exe://mr-dump1090.exe --raw) [reader][i]Connected to the receiver, configuring [reader][i]Configured, processing messages [reader][i]Connection terminated [reader][i]Connecting to DVBT receiver via (exe://mr-dump1090.exe --raw) [reader][i]Connected to the receiver, configuring [reader][i]Configured, processing messages [reader][i]Connection terminated