Announcement

Collapse
No announcement yet.

Reinstalling feeder - feeder does not start

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Oernifly
    replied
    Thank you @Oblivian. This was the command i needed.

    Where could i this command? I searched in forum, FAQs, Rpi "build your own" page of FR24...

    now its working!

    So thanks abcd567 too, but i think the log isn't neccessary anymore

    Leave a comment:


  • Oblivian
    replied
    sudo fr24feed --signup

    Use to be the way if it was successfully actually installed but not configured. (above will show that). If it works still remains to be seen

    Leave a comment:


  • abcd567
    replied
    Copy paste output of following command
    Code:
    cat /etc/fr24feed.ini
    NOTE:
    For privacy reasons, remove value of fr24key from the post.
    Last edited by abcd567; 2018-04-02, 21:57.

    Leave a comment:


  • Oernifly
    started a topic Reinstalling feeder - feeder does not start

    Reinstalling feeder - feeder does not start

    Hey there,

    i am running my Raspberry 3B for more than a year in a row. Last month my SD card stopped working. I bought a new one and reinstalled the feeder software to the 8GB SD card...

    the feeder does not start. Internet connection exists (Ping to FR24.com), Status of fr24feed: FR24 Feeder/Decoder Process...failed!

    The feeder does not appear at flightradar.com/activate-raspberry-pi (There is only my offline Feeder from the old SD card).
    So what are the steps to do a complete reinstall of the software to run the feeder under the same stream key again?

    I dont know what to do...
Working...
X