Originally posted by wiedehopf
View Post
Announcement
Collapse
No announcement yet.
How to use RTL1090+FR24feed+Planeplotter simultaneously
Collapse
X
-
-
No. length from end to end needs to be 13.7 cm.
Not each leg.
13.7 cm from tip to tip.
Use the shorter parts included which can be screwed in.
Anyway your location is very bad.
Try on the roof
Leave a comment:
-
scr14.jpg А/С has become 4. made two counterbalances 13,7sm scr15.jpg I have poor antenna placement. 2nd floor, and around the 10 floors concrete houses.
now I see airplanes around 120km
Now you need to solve the problem why virtual radar and fr24feed do not work together.Last edited by riki; 2019-03-10, 12:49.
Leave a comment:
-
Yeah the cable probably doesn't help either.
It looks like the rtl-sdr blog starter set.
Leave a comment:
-
Originally posted by wiedehopf View PostYour antenna is wrong.
Using such a type of antenna the overall length should be 13.7 cm
If you have the set i believe you have, use the shorter antenna ends and adjust to length from end to end to 13.7 cm.
Leave a comment:
-
Your antenna is wrong.
Using such a type of antenna the overall length should be 13.7 cm
If you have the set i believe you have, use the shorter antenna ends and adjust to length from end to end to 13.7 cm.
Leave a comment:
-
THR XX db [YY] whats this YY and how mutch be XX for good signal? senks :-))
Leave a comment:
-
A/C:2
That's very low. The stats page shows you have sen't data. But you need to receive more than that for longer
Maps (VRS) do not always show real lost/bad signal
Leave a comment:
-
ABCD already demonstrated it works fine with default settings.
Hello, What I'm trying to do is using RTL1090.exe to control DVB-T stick. Let RTL1090 decode data then send to FR24_feed & Planeplotter. When using old version FR24_feed, everything is OK. Planeplotter use port 31001. FR24_feed use port 30003. However, after upgrading FR24_feed to latest version, here comes a
But then you had 0 signal 0 contacts
And now all of a sudden you do. What did you do to make RTL1090 go from 0 traffic to some?
Leave a comment:
-
my fr24feed.ini
receiver="avr-tcp"
fr24key=""
host="localhost:31001"
bs="no"
raw="no"
logmode="1"
procargs="--net"
windowmode="1"
mpx="no"
mlat="yes"
mlat-without-gps="yes"
use-http=yes
http-timeout=20
Leave a comment:
-
Getting a bit over complicated
Why need rtl1090 specifically?
It is only avr if you start RTL with /avr. Should be host 127.0.0.1 , type beast tcp (binary) port 31001
The table is full. So receiving at the stick level OK. But there are no lights on the tcp/UDP connection status in RTL.
Feel free to post/discuss suggestions here http://forum.flightradar24.com/threa...4840#post74840 (http://forum.flightradar24.com/threads/9875-Info-Updates-Ammendments-Placeholder?p=74840#post74840) This guide is not to be taken as officially sourced support information. It is contributor-made Information has been repeated many
Sent from my EML-L09 using Tapatalk
Leave a comment:
Leave a comment: