No announcement yet.

Reset location

  • Filter
  • Time
  • Show
Clear All
new posts

  • Reset location

    Is there a simple way to reset longitude and latitude for a Raspberry Pi installation. My longitude must be a negative value and it is not, putting me somewhere in Russia, rather than near New York City as I actually am.

    Is there a single line of code that directly addresses that parameter, or do I have to go through the entire registration process again.

    Justin Friedland

  • #2
    If you use the map functions of Dump1090 you need to change it in dump1090s config.

    For the feeder once first setup and lodged it is remotely saved on the server and you will need to email support with your ID and correct position to be changed (youll notice it reported on startup as the server sends config). Or you data will be ignored.
    Posts not to be taken as official support representation - Just a helpful uploader who tinkers


    • #3
      Thanks. I'll send the correct info to support.